What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
16.06.2025 02:00

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
What is lightning?
I have the power to talk to aliens through using telepathy. Why do people think I'm crazy?
The third is lightning and “how it gets conducted into a home.”
The other is “what does a “fuse” do?”
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Why are people saying that Trump is fat when he is an athletic 6 foot 3 and 215 pounds?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Upvotes:
He then describes Rainy Season and Lightning.
It seems Mohan does not understand the difference between a comment and an Answer.
One is “what exactly is in a ‘surge protector’ ? ”
Video: Digital Foundry Delivers Its Cyberpunk 2077 Tech Review On Switch 2 - Nintendo Life
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
The MOV will conduct when the voltage exceeds 50% of line voltage.
a photo is worth a thousand words.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is where the MOV conducts again, and dissipated the energy.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
What are some ways to improve speed in sprinting, running uphill, and long/middle distance running?
(Dc diagram shown, AC is similar).
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is 'the assistant's answer'
What is your favourite summer outfit? Why?
These devices are installed between the “hot” and “neutral” and protective ground.
This one hit behind the barn.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
It also is a device that limits the change in current flow.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Can you share 100 facts about yourself?
Now when you have a certain ac resistance, then a current flows in a loop.
the problem then depends on "how fast does the fuse operate?".
But it can get overloaded, and no longer works.
At what stage in your life did you realize, "No, I can't do this any more" and walk out? Why?
Edit 2024–10.
At least they know the answer if they wanted it.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
One
Because the load is inductive, the current lags the voltage.(by a bit).
He then describes the function of a fuse.
[old diagram got deleted by accident]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
But… the neutral is now “floating” because of the 1 ohm resistance.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
What does a fuse do?
[image of Common-mode choke]
In schematic diagrams this is the symbol for a fuse:
This device then solves the entire problem.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
A circuit breaker is similar, but is resettable.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–10–14 [Omar Gharbi Omar Gharbi ]
so, what happens?
I post the exact comment here.
Here is a simplified AC power diagram.
but this device (an Inductor) … impedes the rapid changes in the current.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
So, the voltage could go up to 500 volts, and the fuse will not open up.
At one ohm, the resistor has a maximum of 1 watt power.
2024–10–16 [ OO OLAOYE OYEBODE ]
An AC voltage/ current source, and an ac inductive load.
For this case there are devices called Metal oxide varistors (MOV).
This is where this question deviates from being a 'generic' question, and becomes more specific.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
but I think this circuit , shows a few more pieces.
There are two important concepts here.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
nine
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
First Sentence:
what exactly is a ‘surge’ protector?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
There are three different concepts here that are getting confused.
He then asserts :
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Barnstars:
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
These are simplified answers to the original question, and does not change anything I wrote above.
The bolt then partially travels down the line to your home.
2024–10–10[John johnson John Johnson ]
A fuse is a non-resetable over current circuit protector.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
eight
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.